The Hex ezCAN plugs directly into your motorcycle and listens to the CAN-bus. The best plug and play solution to add accessories to your motorcycle without the need to cut any wires.

This is the latest version of the ezCAN with four high power output channels which have ultimate configuration!

Features

High/Low Sync - Set auxiliary lights to switch between a programmable high/low setting with the factory high beam switch.

ON/OFF and Dim - Independently control two sets of lights ON/OFF and change intensity level (for both day and night) right from your original vehicle switches.

Modulate Lights - Set auxiliary lights to modulate to increase your visibility to other motorists.

Flash to Pass - Need to get someone's attention? Pulse your high beam switch three times and your auxiliary lights will strobe three times fast.

Cancel With Turn Signal - This feature cancels the corresponding auxiliary light when you turn your turn signal on preventing powerful auxiliary lights from overpowering your signal.

Inverse Flashing With Hazards - This features flashes your auxiliary lights inversely to your hazard lights, increasing visibility during road side emergency's. 

Strobe with Horn - With this feature selected the software will automatically strobe your auxiliary lights when you sound your horn. This feature works whether you have the factory horn or SoundBomb™ horn installed.

Deceleration Activated "Smart Brake" Technology - Reads vehicle speed in real time to activate your auxiliary brake light during deceleration before you even touch the brake. You can adjust the sensitivity and minimum speed at which the Smart Brake Feature will activate.

Flash Pattern Braking - Provides four different flash patterns that make our super bright auxiliary brake lights even noticeable to motorists behind you. You can set auxiliary brake lights to only flash under hard braking, flash continuously as your brake is applied or flash four times rapidly then hold steady (California legal flash rate).

Circuit Function Selector - The Circuit Function Selector in the software will let you run any accessory of your choice on any of the four circuits. Click on a circuit icon to open the drop down menu and make your selection from the list of available circuit functions.

Switched Power Source - Provides a universal "accessory" option which simply gives you clean switched 12V power. That means whatever accessory you connect to this circuit will turn on and off with your ignition.

Delay Time Out - You can also set the accessories on this circuit to have a delayed time out. This will keep them powered for up to 30 seconds after your turn off your bike.

On Board Power - The "accessory" circuit option is ideal for powering your GPS, phone, heated gear or any other electronic device.

This device works on the following  models

●  R1200GS – K25
●  R1200GS Adv – K25
●  R1200RT – K26
●  R1200R – K27
●  R1200ST – K26
●  R1200S – K29

Add the HARNESS KIT if you intend to run a soundbomb horn and/or front auxiliary lights.  The Hex ezCan and Hex Harness Kit together make it a direct replacement for the Denali Cansmart which has a harness kit included by default.